Using your Makita GSH01M1 circular saw is easy. First, make sure the battery is fully charged and properly inserted into the saw. You can use the on - board hex wrench to install or remove the blade. When you're ready to cut, turn on the saw. The LED lights will come on to help you see the cutting area clearly. The saw has an electric brake, so when you release the trigger, it will stop quickly. For bevel cuts, adjust the saw to the desired angle using the positive stops at 22.5°, 45°, and 56°. If you have an AWS - compatible dust extractor and the Auto - start Wireless Transmitter, pair them with the saw via Bluetooth. The dust extractor will turn on and off automatically as you start and stop the saw. Here are some important notes. Always wear safety goggles, gloves, and ear protection when using the saw. Don't use the saw in wet conditions unless it's necessary, but remember the XPT™ technology helps protect it from water and dust. Don't over - load the saw; if it starts to slow down under heavy load, ease up. For maintenance, keep the saw clean after each use. Wipe off any dust or debris, especially from the blade and the air vents. Check the blade regularly for sharpness and replace it if it's dull. Store the saw and the battery in a cool, dry place. Charge the battery as needed, and use the XGT® Rapid Charger for the best results. The charger's dual - fan design will cool the battery quickly, and the digital display will show you the charge level.
