This Bosch GAM 270 MFL All-in-One Digital Angle Finder and Inclinometer is a must - have tool for precision work. Inside the package, you'll get a digital angle finder and inclinometer, four AA batteries, a 24 - inch leg extension, and a handy carrying case. It combines five essential tools in one: a digital angle finder, inclinometer, miter calculator, protractor, and level. The digital angle finder gives you super - accurate angle targets, and it can store angle and inclinometer measurements in memory for repeated use. The inclinometer provides precise measurements in both degrees and percentages. With two easy - to - read illuminated, flip displays for the inclinometer and angle finder, you can easily view data. The 24 - inch leg extensions and manual angle finder leg lock allow you to reposition at the same angle. An integrated laser helps transfer inclination measurements up to 100 ft. It has a robust housing with IP 54 protection, making it durable. There's also a cut calculator for easy angle adjustments and a compound miter calculator. And it's easy to calibrate in the field for consistent results. The tool can handle compatible angles from 0 to 270 degrees and compound cut input angles from 0 to 180 degrees, with angle accuracy of 0.01' and leveling accuracy of 0.05'. It automatically shuts off after 30 minutes to save battery.
Using this Bosch angle finder and inclinometer is easy. First, take it out of the carrying case and insert the four AA batteries. Then, turn it on. You can use the digital angle finder to get accurate angle targets. If you need to measure the same angle again, just use the memory function to recall the previous measurement. The inclinometer can give you precise measurements in degrees or percentages. When using the leg extensions, extend them to the desired length and lock them in place with the manual lock. The integrated laser is great for transferring inclination measurements. Just point it at the target up to 100 ft away. For saw angle adjustments, use the cut calculator. And if you need to measure non - perpendicular joint angles, the compound miter calculator is your go - to. As for maintenance, keep the tool clean and dry. Since it has IP 54 protection, it can resist some dust and splashes, but don't submerge it in water. When not in use, turn it off to save battery. Also, if the measurements seem off, use the easy field calibration feature to get accurate results again.
