Using the DeWalt DCF682N1 is easy. First, make sure the battery is charged. You can check the Battery State of Charge display on the tool. To start working, just pick up the screwdriver. You can drive or reverse fasteners by simply twisting the tool left or right. Adjust the speed as needed; it goes from 0 - 430 rpm. When you're working in a tight or dark space, turn on the lighted illumination. Changing bits is a breeze; use the 1/4 - inch hex to quickly swap in a new 1 - inch bit tip. As for maintenance, keep the tool clean. After use, wipe it down with a dry cloth. When not in use, store it in the provided case. Also, charge the 8V MAX battery fully every few months, even if you're not using the tool, to keep it in good condition. Remember, always handle the tool with care and follow all safety instructions.
