Using the Makita GEC01PL4 power cutter is straightforward. First, make sure the batteries are fully charged and properly inserted into the tool. Connect the water hose coupling if you're doing concrete cutting to keep the blade cool and meet OSHA requirements. Adjust the water flow as needed using the knob. When starting the cutter, press the lock - off power switch in two steps to ensure safety. The soft start feature will make the start - up smooth. For cutting, position the tool carefully. The 14 - inch wheel can make single - pass cuts up to 5 inches deep in masonry and metal. Use the adjustable blade guard to suit different cutting positions, like low or upper wall zones. The rubberized front handle can be held in multiple ways for comfort. If the cutting wheel gets jammed, the Active Feedback - Sensing Technology (AFT) will turn off the motor to protect you. The electric brake helps you reposition the tool quickly. When it comes to maintenance, keep the tool clean, especially after using it in dusty or wet conditions. The Extreme Protection Technology (XPT) helps with dust and water resistance, but still, wipe it down regularly. Check the batteries' charge level and store them in a cool, dry place. If you need to change the wheel, use the large spindle lock button, which is easy to use even when wearing gloves. Don't forget to follow all safety instructions and wear appropriate protective gear like goggles, gloves, and ear protection.
