DeWalt DWASHRIR 18 GA Shear Attachment

Using the DeWalt 18 GA Shear Attachment is a breeze. First, make sure your 18V - 20V impact driver or drill is turned off. Then, insert the 1/4” hex shank of the shear attachment into the tool's chuck and tighten it properly. When you're ready to cut, hold the tool firmly and start the motor. The 360 - degree swivel head allows you to easily change the cutting direction as needed. As for the materials, you can use it on a wide range of 18GA stuff like sheet metal, shingles, and more. Just keep in mind that for safety, always wear protective gear like gloves and goggles. Also, avoid using it on materials thicker than 18GA as it may damage the attachment. To maintain it, after each use, wipe off any debris and keep it in a dry place. If it gets dirty, you can clean it with a mild cleaner, but don't submerge it in water.